True orthodontic emergencies are rare, but when they occur we are available to you. As a general rule, you should call our office when you experience severe pain or have a painful appliance problem you can’t take care of yourself. We’ll be able to schedule an appointment to resolve the problem.
You might be surprised to learn that you may be able to solve many problems yourself temporarily until you can get to our office. If there is a loose piece that you can remove, put it in a plastic bag or envelope and bring it with you to your next appointment. If your braces are poking you, put soft wax on the piece that’s sticking out. If the wire has slid to one side, you can pull it back to the other side with needle-nosed pliers, replacing it in the tube on the back tooth.
After alleviating your discomfort, it is very important that you still call our office as soon as possible to schedule a time to repair the problem. Allowing your appliance to remain damaged for an extended period of time may result in disruptions to your treatment plan.
Using a pencil eraser, push the poking wire down or place wax on it so that it is no longer poking.
If the pokey wire is in the back, due to a broken bracket or a wire protruding past the last bracket, wax does not work very well. A few things can be tried.
1. Sometimes the wire “creeps” to the left or the right. If you are new in braces with a lighter wire, you can try slowly and gently “scooting” the wire to move it to the other side. This will not work in heavier wires with bends.
2. You can also try using a clean pair of toe-nail clippers to clip the wire if you are new to braces and in a lighter wire. Again, this will not work in heavier wires and can break off the bracket.
3. If wax will not stick, we recommend placing a chewed piece of bubble gum or a piece of cotton on the bracket/wire to get you through the weekend, and we will assist you when we return to the office the following week.
If your appliance is poking you, place wax on the offending part.
If your bracket or band is still attached to the wire, you should leave it in place and put wax on it if needed for comfort. If the bracket or band can be removed easily, place it in an envelope and save it to bring to your next appointment.
Using a pair of tweezers or needle-nosed pliers, try to put your wire back into place. It is okay to use a piece of floss to tie the wire into place: tie the floss around the bracket in place of the missing colored o-ring. If you cannot put the wire into a comfortable position, and covering the end with wax doesn’t help, as a last resort use a small fingernail clipper to clip the wire behind the last tooth to which it is securely fastened. If the end of the wire is still sharp place wax on it.
Sometimes discomfort is caused by not wearing the headgear as instructed by your orthodontist. Please refer to the instructions provided by your orthodontist. If the facebow (metal piece) is bent, please call our office for assistance. The headgear should hurt less the more it’s worn, so be sure you get in the prescribed number of hours.